#Ruby runner bog plant install

Turn on your pump and your bog filter is now off and running with years of clear water enjoyment to come.

In other words, no standing water in the gravel filter area. Your goal is to place the plants at the appropriate level so that when the rest of the gravel is added the gravel level will be above the water level.

After the plants have been placed, gently shovel in the remaining gravel.

(Trust us the soil will not wash into your pond.) Do not remove the soil-there is not enough nutrition in a brand new bog to sustain the plants.

After you have arranged the plants to your satisfaction knock the pots off the plants and place the plant with the root ball intact with soil.

Create interest by contrasting plants with different foliage colors or textures. It’s best to plant the tall plants towards the back of the filter, lower growing plants in front.

Select your bog plants and arrange them in the bog area that is half filled with gravel.

After all, that’s what the filter is designed to do! The construction process is finished, now it’s time to plant your bog! Most gravel is not very clean, wash it as best you can in the wheel barrow but be aware it will muddy up the pond, not to worry it will clear up.

Shovel 3/8” pea gravel into the Bog Filter area but only fill halfway.

This layout is similar to setting up a septic drain field. Wider areas require additional lines spaced 2-3’ apart.

Gravel bogs that are 2-3 feet in width can be fed by a single course of pipe. Once you are satisfied with your piping layout, glue all parts together. Be sure to point the holes at a 45 degree angle toward the bottom. Next lay the distribution pipe on top of the pond liner in the area partitioned off for the bog filter.

The spacing is an approximate estimate, if there is a long run of pipe space the holes further apart. The pipe is drilled with 1/4” holes spaced approximately 6” apart. For example our 5500 gph AquaFlo pump has a 2” outlet therefore 2” pipe is used. The outlet of the pump determines the size of the pipes. (You can go with a higher flow rate if you wish.) Select a pump that will turn the volume of the pond over every 1-2 hours. This is to facilitate good circulation of water throughout the pond.

#Ruby runner bog plant install

Install the pump on the opposite side of the pond from where the bog filter is located.

Put a PVC female adapter fitted with the appropriate sized hose barb fitting to receive the flex hose from your pump.

Be sure to run a piece of pipe through the lower portion of the wall that will hook the pump to the pipe work in the bog filter.

We recommend using cinder block (painted black with exterior latex paint) and then “capping off” the blocks with a decorative stone of your choice.

Using Cinder Block, Stone, Bricks or any other stable building material construct a dry wall to partition off the bog filter from the rest of the pond.

If you plan to stock a lot of fish or Koi err on the larger size. the bog filter should take up 10 to 20 sq. For example if you have a 10’ x 10’ pond equaling 100 sq. The bog filter portion of the pond should be anywhere from 10-20% of the pond surface.

Follow the usual directions for building a liner pond.

The bog filter is actually a garden that functions as a filter! Directions Using Mother Nature’s Model we can install filters in our ornamental water gardens that are highly effective and natural in appearance. In addition to providing a habitat for moisture loving organisms a wetland also functions as a filter for Mother Nature. In Nature bogs or wetlands are low lying areas in the natural terrain where flora and fauna thrive in a moist environment.